Run the command #snmpconfig -set snmpv3 and hit enter until you reach the trap number you want to change. This will reset the IP addresses to 0.0.0.0 for all trap entries and then one can re-assign the IP address.Ģ. Set the entire snmp configurations to default by using command. There are 2 ways to remove the IP addresses assigned to the snmp trap configurations.ġ. SNMPv3 Trap/Informs configuration: Trap Entry 1: 172.x.x.20 Trap Port: 162 Trap User: switch_snmp Trap recipient Severity level: 1 Notify Type: TRAP(1) Trap Entry 2: 10.x.x.20 Trap Port: 162 Trap User: switch_snmp Trap recipient Severity level: 2 Notify Type: TRAP(1) Trap Entry 3: 172.x.x.50 Trap Port: 162 Trap User: switch_snmp Trap recipient Severity level: 3 Notify Type: TRAP(1) Trap Entry 4: 171.x.x.30 Trap Port: 162 Trap User: SNMP_user1 Trap recipient Severity level: 1 Notify Type: TRAP(1) Trap Entry 5: 172.x.x.30 -> Removing this IP Trap Port: 162 Trap User: SNMP_user1 Trap recipient Severity level: 2 Notify Type: TRAP(1) Trap Entry 6: 170.x.x.30 Trap Port: 162 Trap User: SNMP_user1 Trap recipient Severity level: 3 Notify Type: TRAP(1) Solution: Following is an illustration for SNMP Version 3 :
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |